The IP address as you need to assign all of device

To troubleshoot HSRP there are two-step

Step 1: Verify configuration and Ping to Webserver

a. Make sure all device such as PC, Laptop, Switches, and router are configured
correctly the information provided. In this process, you need to check one by one
on each device configuration IP Address, Subnet Mask, and default getaway.

b. Verify and ping from PC to webserver (www.cisco.pka) reachable and successfully

Step 2: Verify configuration and Troubleshoot on Router 1

Use command show standby brief to find the issue on Router 1

On Router 1

R1#show standby brief
P indicates configured to preempt.
|
Interface Grp Pri P State Active Standby Virtual IP
Gig0/1 11 50 Active local unknown 192.168.1.254

R1(config)# int gi0/1
R1(config-if)# no standby 11
R1(config-if)# standby 1 ip 192.168.1.254
R1(config-if)# standby 1 priority 101
R1(config-if)# standby 1 preempt

On Router 2

R2#show standby brief
P indicates configured to preempt.
|
Interface Grp Pri P State Active Standby Virtual IP
Gig0/1 111 100 Active local unknown 192.168.1.254

R2(config)# int gi0/1
R2(config-if)#no standby 111
R2(config-if)#standby 1 ip 192.168.1.254
R2(config-if)#
%HSRP-6-STATECHANGE: GigabitEthernet0/1 Grp 1 state Speak -> Standby

Lab file is taken from netacad.com

By Admin